Page 1 of 1

Question regarding Purity

PostPosted: Fri Sep 07, 2012 3:36 pm
by Stannoman
I recently heard some stuff about implementing purity and then getting rid of purity again.
My question: Does the purity of dowsing rods still have any use? Was it perhaps something else that was removed or changed?
Basically I have been trying to find a mine nearby using a 0% Pure Woo-Woo-Rod, I haven't found anything in hours, while trying out the tactics described on the wiki, and forums. I read that if you use different purity rods, you find different nodes, so if I used for example 4% dowsing rods, would I theoretically find different nodes? Or was, like I said before, something changed with all this purity stuff and now it doesn't matter?

Thanks in advance.

Re: Question regarding Purity

PostPosted: Fri Sep 07, 2012 4:09 pm
by milonti
Different purity values of dowsing rods will find different mines. They find mines with similar elemental composition to the rods, which means of similar (and possibly higher) purity.

Re: Question regarding Purity

PostPosted: Fri Sep 07, 2012 4:11 pm
by Sevenless
You find different sets of mines with different purity rods. So you might have a mine near you of a different purity than 0%

Dowsing is also kinda tricky. Just walk in a grid pattern.

Re: Question regarding Purity

PostPosted: Fri Sep 07, 2012 6:50 pm
by Stannoman
Thanks guys! Clear answers.