Salem

Hello all,

I was wondering if it is possible to build stone hedge walls ascending or descending on slopes? and if so, to what degree of slope will the walls accept?

Thanks

Confirmed:
- Posts can be built on land that isn't completely flat.
- wall sections can be built on extreme slopes of 5+ above level.

Yes, and I'm unsure because I haven't tested it.

So the ground dosent have to be totaly flat from fence piece to piece, they will build up slopes? I really dont want to have to tear down a fence after i place it...

can confirm you will connect if the ground is flat, but not on exact same level.

ok cool, at least i know i can build my fence where i want it then, Ill do some test pieces on the ascending areas and let you guys know how much of a slope is to much. It will be a while yet till i start though, check back tomorrow.

Can confirm that 2 heigh units / tile slope is flat enough for a fence.

Potjeh wrote:Can confirm that 2 heigh units / tile slope is flat enough for a fence.

is that the maximum?

I have confirmed that the posts dont have to be completly level to start them. Ive also confirmed that wall sections are capable of extending up extreme slopes. Im not entirely sure how extreme yet, but at least 4 - 6 points above level form what i can tell so far.

Before wipe I had a wall built on slopes with alternating flat and +5 point tiles.

Has anyone messed around with this lately or gotten anymore info? I'm foolishly building up on a cliff and between flattening land and building walls I've run into some problems with slopes for my stone hedge.
To build on a slope, does anyone know if the points need to be equal on at least to sides, for example: 4____4
| |
2____2

Based on what I'm exp. I'm gonna put it out there as no.....but looking for someone to validate my assumption.

Also, I'm building my third wall layer and all of a sudden I get the "Ground not flat enough" notification when I got to put a section down. Problem is, the tile is EXACTLY the same (Slope, height of points) as the tile next to it and the tile next to the one, both having a wall segment. Does anyone know if the level you are extending from (Ascend vs. Descend) makes a difference?

Thanks in advance for any replies.