Page 1 of 1
Cut down trees stuck in objects

Posted:
Sun Apr 14, 2013 6:07 pm
by T0ne
I decided to cut down a few more trees around the perimeter of my base and while I did not even notice at first, it seems that two of them have fallen "into" my base and cannot be picked up or interacted with. One fell directly into a house and another right through a wall.
I am guessing if I was to destroy the house/walls that covered them I would then be able to remove them. Is there any other options or am I stuck?
Re: Cut down trees stuck in objects

Posted:
Sun Apr 14, 2013 6:10 pm
by MagicManICT
That's all. They're stuck there unless you're willing to remove those objects.
Re: Cut down trees stuck in objects

Posted:
Sun Apr 14, 2013 8:00 pm
by Alexivo
Sometimes you can still reach them to chop with your axe. It may take a while, but it may allow you to clean them up.
Re: Cut down trees stuck in objects

Posted:
Sun Apr 14, 2013 10:00 pm
by Hans_Lemurson
When testing out my first canoe, I was able to salvage two logs from neighbors on the lakeshore who had chopped a tree into deep water.
I'm sure a canoe is also the appropriate tool for this endeavor.
Re: Cut down trees stuck in objects

Posted:
Sun Apr 14, 2013 10:16 pm
by JinxDevona
Keep in mind while chopping trees, they will fall in the direction your toon is facing.
Re: Cut down trees stuck in objects

Posted:
Mon Apr 15, 2013 8:22 am
by Wournos
JinxDevona wrote:Keep in mind while chopping trees, they will fall in the direction your toon is facing.
And approximately 4 tiles away.
Re: Cut down trees stuck in objects

Posted:
Mon Apr 15, 2013 7:46 pm
by qbradq
The center of the tree (the spot you need to get to in order to lift it) will be about 6 1/2 or 7 tiles away from the stump.