Page 1 of 1
Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 12:28 amby AcidSpiral
I am trying to build a pilgrim's hovel and it keeps saying "Cannot build that here". I have dug and flattened the land and I'm not sure what is required of the land before I can build this. Any advice?
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 1:09 amby MagicManICT
Make sure you have enough space for it. Most players make the mistake of not leveling a large enough area. Extend an extra tile in each direction and everything should work.
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 1:50 amby AcidSpiral
Okay. I apparently didn't have enough space so now it's saying the ground is not flat enough but I cannot really tell which part I need to lower. Is there an easy way to tell land elevation?
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 2:33 amby qbradq
Get Ender's Client and use the CTRL+L tool. Ender's Client can be found
here.
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 3:10 amby AcidSpiral
Thanks!
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 3:35 amby Khors
qbradq wrote:Get Ender's Client and use the CTRL+L tool. Ender's Client can be found
here.
Best advice for any newb and best client, imho...required.
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 3:49 amby Orcling
qbradq wrote:Get Ender's Client and use the CTRL+L tool. Ender's Client can be found
here.
isnt it CTRL+F ?
Re: Pilgrim's Hovel
Posted:
Tue Mar 26, 2013 10:07 amby Wournos
Orcling wrote:qbradq wrote:Get Ender's Client and use the CTRL+L tool. Ender's Client can be found
here.
isnt it CTRL+F ?
No, CTRL + L
Also, holding CTRL while digging forces the tile to turn out completely flat.