Page 1 of 1

wall build problem

PostPosted: Wed Nov 04, 2015 10:26 am
by Trismegistus
Image


Image in spoiler.

The problem here is that I can't extend the brick wall. Trying from both ends, I get the option for either cornerpost, extend north, extend south but when I choose the option I want, the character moves toward it and then does nothing. I think the problem is either that the brazier is full of ammo, full of +0 purity ammo, or this is a meeting point of two brick walls that have separate starter corners. I have been able to build a brick wall next to full ammo and +0 purity ammo a few times before, but iirc that has always been the last segment running into a corner post.

The problem existed before I built the plank fence right up to the gap. That is not the issue.

Re: wall build problem

PostPosted: Wed Nov 04, 2015 10:47 am
by Lusewing
The Braizers have a funny hit box and while the other braizers have caused you no problem you will proberly find that this one is turned at a slightly diffrent angle and this is getting its hit box in the way. The fuel has no effect. You will need to distroy the brazier, build the wall and then replace the braizer. Have fun.

Re: wall build problem

PostPosted: Wed Nov 04, 2015 10:59 am
by Trismegistus
Thank you. That should be no problem. I was scared of it being the two different brick wall starters meeting, and I'd have to smash the brick back to a corner or sumtin. But, yes, that should definitely be it. I know this one was built before I started to build every brazier with the exact same positioning.

Re: wall build problem

PostPosted: Wed Nov 04, 2015 3:34 pm
by strawman
Are you actually able to squeeze between that gap?