Page 1 of 1
Shaving down little cliffs

Posted:
Wed Sep 23, 2015 5:13 am
by strawman
Need some pro tips on how to best shave down a little cliff like this:

Re: Shaving down little cliffs

Posted:
Wed Sep 23, 2015 5:47 am
by JamesBonham
This one is hard because of the stone quarry around it. You could dig up some earth from a near hill and place it on one side, until you get rid of the double-cliff.
Re: Shaving down little cliffs

Posted:
Wed Sep 23, 2015 7:25 am
by Telcular
Don“t try to make it disapear, place loads of crickets, crabs and frogs below it, then stand ontop holding a rabbit to the sky while singing Circle of life.
Re: Shaving down little cliffs

Posted:
Wed Sep 23, 2015 10:41 am
by LOMS
This is impossible, until we have changed digging rules or a land survey tool like in Haven & Hearth.
Re: Shaving down little cliffs

Posted:
Wed Sep 23, 2015 10:43 am
by Procne
It might be possible if you were able to raise the ground enough to the right-down from the ledge. Kinda hard to tell from the screen if the stone quarry would allow that
Re: Shaving down little cliffs

Posted:
Wed Sep 23, 2015 10:53 am
by Forungi
I have removed cliffs like these, however, none of them were located in the center of a quarry like this one.
The way I did it was I just dug out a bunch of dirt from around the area, and placed it down infront of the cliff. Eventually it turned into a hill that allowed me to flatten it down.