Salem

Hello all,

I was wondering if it is possible to have one wall intersect another wall and seal between the 2. Ill try and make an example below.

0==========0
45645|
45645|
45645|

= = fence
| = fence
0 = corner post

Thanks all

I believe when you do it like that you usually run into the hitboxes of the walls not lining up properly and you end up with a gap where you can't put a fence piece if you're using two different start posts. I'm 95% sure if you're using the same starting corner post it all works out and there's no real gaps.

Sadly I can't tell you from recent experience, this is hazy memory from a while back. Someone with more recent knowledge can pipe up hopefully.