jwhitehorn wrote:God damn your stuipd.....
Chief PeePooKaKa
MM Tribe
MaxPlanck wrote:Is there any other instructions to be installing this client other than replacing the salem.jar, I also got the refused connect and didn't know what else there could be done, would removing salem from the computer completely and installing a fresh new ender client then replacing salem.jar help possibly?
jorb wrote:(jwhitehorn) you are an ungrateful, spoiled child
Kandarim wrote:Ah yes, I used the control+F shortcut for a tool idea which was taken out after, but the hotkey was never reinstated for the flatnesstool. On my list I've always used ctrl+L myself.
@drmex: a lot of people play mouse+keyboard at the same time, so yes those have only the left hand available for the keyboard.
Current other ideas for the next version:
Make the client remember claim visibility settings (by extension, homestead and heightmap too)
Fix the homestead pointer issue, where the old one does not disappear after moving your homestead.
jorb wrote:(jwhitehorn) you are an ungrateful, spoiled child
Darwoth wrote:looks like a good client, haven't tried it out myself because enders works and i trust his client where i am always wary of new ones from new sources. but since you seem to have been bitten by the "new features" bug figured i would suggest a rangefinder for guns, could be as simple as a colored line the same length as gun range that can be toggled on/off coming from the front of your character.
jwhitehorn wrote:God damn your stuipd.....
Chief PeePooKaKa
MM Tribe
loftar wrote:***** the treaty.
MaxPlanck wrote:Is there any other instructions to be installing this client other than replacing the salem.jar, I also got the refused connect and didn't know what else there could be done, would removing salem from the computer completely and installing a fresh new ender client then replacing salem.jar help possibly?
JC wrote:I'm not fully committed to being wrong on that yet.
Kandarim wrote:MaxPlanck wrote:Is there any other instructions to be installing this client other than replacing the salem.jar, I also got the refused connect and didn't know what else there could be done, would removing salem from the computer completely and installing a fresh new ender client then replacing salem.jar help possibly?
Make sure that afterwards you start the client as you started Ender's client before, through his jnlp file. Make sure you delete no other file in the Salem/bin folder.
Users browsing this forum: No registered users and 73 guests